Disk copier doesnt allow target to a flux file with combo drive?
#1
Greetings,

Been trying out various drives with the supercard pro and I got my hands on a dual combo Epson SD-800 drive. When connected it acts as 2 separate drives and the supercard pro detects them properly as separate drives. My issue is when you go to the disk copier/imager, the target device selection box only allows you to select drive 0 and drive 1 instead of a flux file. Amiga and C64 (my main dumping needs) allow you to select ADF or G64 but still no raw flux file. I clicked reset to defaults and briefly had flux file show back up in the target devices but it vanished again on program restart. Am I doing something wrong or is this just wierdness with this combo drive?

Wasnt sure if I should put this in software or hardware since it could go either way.

Thanks again for the awesome device, I've been loving it after I put some time into learning the ropes...

-aphexian
Reply


Messages In This Thread
Disk copier doesnt allow target to a flux file with combo drive? - by aphexian - 11-09-2015, 09:35 PM



Users browsing this thread: 1 Guest(s)