Drive not being detected on scan

[admin]

Your drives should have jumpers on FH and DS2 only (not DS1 or any other setup). DS2 means use the cable to determine the drive number. The outer drive connector (with the twist) is drive 0, the inner drive connector (closest to the SCP board) is drive 1. Make sure you are not swapping ends of the cable... the longer portion with a single 34 pin connector (with the missing pin key) plugs into the SCP.

You should never have to actually power down or remove anything. Just re-launching the SCP software (after changing the drives on the cable) will re-scan the drives and determine what drive(s) are present.