08-11-2015, 04:51 AM
I, too, have a TEAC FD 55 GFR drive. My problem is that the SCP does not recognize the drive.
(The SCP has worked properly with a Panasonic 3.5 drive, so I believe the software and driver
installation is correct. Also, the same power supply is used for both drives, so I don't think that
is the source of the problem, either.)
When I run the SCP software no drive is listed in the drop-down boxes, and when I try to use a
utility such as maximum track, the drive light comes on but the drive does not spin. I have
checked the jumper settings, according to TEAC's manual: DC is ON, D0 and D1 have both used
as configuration settings. I am using a twisted cable, farthest connector, pin one toward the
power connector.
Is there something I am missing or is this just a defunct drive? Thanks for your replies.
(The SCP has worked properly with a Panasonic 3.5 drive, so I believe the software and driver
installation is correct. Also, the same power supply is used for both drives, so I don't think that
is the source of the problem, either.)
When I run the SCP software no drive is listed in the drop-down boxes, and when I try to use a
utility such as maximum track, the drive light comes on but the drive does not spin. I have
checked the jumper settings, according to TEAC's manual: DC is ON, D0 and D1 have both used
as configuration settings. I am using a twisted cable, farthest connector, pin one toward the
power connector.
Is there something I am missing or is this just a defunct drive? Thanks for your replies.