+- CBMSTUFF FORUM (https://www.cbmstuff.com/forum)
+-- Forum: CBMSTUFF PRODUCTS (https://www.cbmstuff.com/forum/forumdisplay.php?fid=1)
+--- Forum: WiModem (https://www.cbmstuff.com/forum/forumdisplay.php?fid=75)
+---- Forum: Usage (https://www.cbmstuff.com/forum/forumdisplay.php?fid=77)
+---- Thread: WHD Program (/showthread.php?tid=620)
Pages:
1
2
RE: WHD Program - armitage - 10-16-2020
Tried whd for the first time today and I'm having the same issues as the others. 9600 baud, at&k1 set, directory works in CCGMS, but when I start the whd wedge and load"$",7 it freezes on "Loading. I tried it with JiffyDOS enabled and disabled on both my NTSC breadbin and flat 128. Running latest WiModem firmware. Tried an at&f just to see if that would make a difference but got the same result.
RE: WHD Program - admin - 10-17-2020
Hmm... I will look into it.
RE: WHD Program - admin - 05-24-2021
Update to the latest (v4.00) firmware and use the latest WHD. I have fixed all of the little issues. Now you can leave your WiModem in 2400 baud mode and WHD will automatically switch it to 9600 baud and run correctly.
RE: WHD Program - pcollins - 05-24-2021
Only NTSC, right?
RE: WHD Program - admin - 05-24-2021
No, it should handle both NTSC and PAL. Although, I have not tested it with PAL I do have the timing set for PAL systems. If you have a PAL setup, please test it and let me know! Thanks!
RE: WHD Program - admin - 10-24-2021
Yes, the UP9600 hack is required as the WHD program runs only at 9600 baud. At some point I will enable the 38400 baud support that I have been working on.
RE: WHD Program - ZippyZapp - 10-24-2022
(10-24-2021, 05:58 PM)admin Wrote: Yes, the UP9600 hack is required as the WHD program runs only at 9600 baud. At some point I will enable the 38400 baud support that I have been working on.
Cool. Looking forward to that. I am glad new stuff for the WiModem is still being worked on.