The following warnings occurred:
Warning [2] Undefined property: MyLanguage::$archive_pages - Line: 2 - File: printthread.php(287) : eval()'d code PHP 8.1.28 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/printthread.php(287) : eval()'d code 2 errorHandler->error_callback
/printthread.php 287 eval
/printthread.php 117 printthread_multipage



CBMSTUFF FORUM
has anyone tried connecting wimodem to wimodem ? - Printable Version

+- CBMSTUFF FORUM (https://www.cbmstuff.com/forum)
+-- Forum: CBMSTUFF PRODUCTS (https://www.cbmstuff.com/forum/forumdisplay.php?fid=1)
+--- Forum: WiModem232 / WiModem232 Pro (https://www.cbmstuff.com/forum/forumdisplay.php?fid=79)
+---- Forum: Usage (https://www.cbmstuff.com/forum/forumdisplay.php?fid=81)
+---- Thread: has anyone tried connecting wimodem to wimodem ? (/showthread.php?tid=469)

Pages: 1 2

RE: has anyone tried connecting wimodem to wimodem ? - admin - 03-25-2018

That's a WiFi ping to the RF module.  The ping test I am talking about is modem to modem done serially.

RE: has anyone tried connecting wimodem to wimodem ? - BODYPRINT - 03-26-2018

Hi. I'm the other party that was trying Modem to Modem with sean_skroht over the weekend.
I was searching for a terminal ping command but couldn't find any.
How do we ping over terminal?

Also we managed to hookup the modems directly to each other without going through the router to try and reduce any latency but they both had the same IP address. (192.168.20.4 from memory)
Is it possible to add a manual Change IP address command along with the 9 bit parity discussed earlier?

RE: has anyone tried connecting wimodem to wimodem ? - admin - 03-26-2018

It's not possible to change the IP address (currently).  I am pretty sure that WiModem to WiModem direct is going to have the same problem with latency.  Remember that serial to serial is just that... there is not middle layer like the WiModem has.  That middle layer is the WiFi transmission/reception and stack for translation.

Until I have information on what 9 bit mode is actually needed, I can't doing anything with this.  The mode needed may not even be possible with the RF module I am using.