SuperCard+ v6.0 - Printable Version +- CBMSTUFF FORUM (https://www.cbmstuff.com/forum) +-- Forum: CBMSTUFF PRODUCTS (https://www.cbmstuff.com/forum/forumdisplay.php?fid=1) +--- Forum: Supercard+ (https://www.cbmstuff.com/forum/forumdisplay.php?fid=4) +---- Forum: Software (https://www.cbmstuff.com/forum/forumdisplay.php?fid=23) +---- Thread: SuperCard+ v6.0 (/showthread.php?tid=2) |
SuperCard+ v6.0 - admin - 11-01-2013 Here is the last version of the SuperCard+ software that was released by Utilities Unlimited. The 3 side (2 disk) set has been converted to .d64 format. Supercard+ v6 archive RE: SuperCard+ v6.0 - dlgarman - 03-27-2020 Hi Jim, Hope your doing Ok. Say, what's the deal with this error:The requested URL /dev.cbmstuff.com/dev.cbmstuff.com/downloads/sc+v6.zip was not found on this server. I get that whenever I try to d/l anything here. Thanks for your time. Dennis RE: SuperCard+ v6.0 - admin - 03-27-2020 Sorry, the link has been fixed. I made the entire site SSL, and I forgot to add the 's' in https. RE: SuperCard+ v6.0 - dlgarman - 03-27-2020 (03-27-2020, 05:57 PM)admin Wrote: Sorry, the link has been fixed. I made the entire site SSL, and I forgot to add the 's' in https.Thanks a bunch, Jim. Could I maybe get the pictures of how to install the speed control also? That would be grand.Thank you, Dennis RE: SuperCard+ v6.0 - admin - 03-27-2020 Hmm... I am not sure what happened to the pictures of the 1571 speed controller installation. They were in the 1571 installation thread. I will try to find them again! If you don't have a 1571 then you can use the adjustment pot for the 1541/C (nothing we can do about most of the 1541-II drives). RE: SuperCard+ v6.0 - dlgarman - 03-27-2020 (03-27-2020, 09:06 PM)admin Wrote: Hmm... I am not sure what happened to the pictures of the 1571 speed controller installation. They were in the 1571 installation thread. I will try to find them again! If you don't have a 1571 then you can use the adjustment pot for the 1541/C (nothing we can do about most of the 1541-II drives). Well, that's a shame. I need them for 1 of my drives it's a 1571. but I will live. Thankfully my other drive is a 1541c so it should be good to go. Thank's so much, Dennis RE: SuperCard+ v6.0 - admin - 03-27-2020 I fixed the pictures for the 1571! RE: SuperCard+ v6.0 - dlgarman - 03-27-2020 (03-27-2020, 09:36 PM)admin Wrote: I fixed the pictures for the 1571! Great, THANK YOU! Dennis. RE: SuperCard+ v6.0 - dlgarman - 04-12-2020 Another Question. I now have a working parallel cable installed in my 1571. What do I need to do to get the parallel copier to work? A 1541? Thanks for your time. Dennis P.S. The cable I have installed with my Supercard+ is a 10 conductor cable. RE: SuperCard+ v6.0 - admin - 04-12-2020 The Supercard+ parallel copier works with a 1541 or 1571 as long as you have a Supercard+ board installed in the drive. |