CBMSTUFF FORUM
Latest beta firmware - changes - Printable Version

+- CBMSTUFF FORUM (https://www.cbmstuff.com/forum)
+-- Forum: CBMSTUFF PRODUCTS (https://www.cbmstuff.com/forum/forumdisplay.php?fid=1)
+--- Forum: SuperCard Pro (https://www.cbmstuff.com/forum/forumdisplay.php?fid=3)
+---- Forum: Hardware (https://www.cbmstuff.com/forum/forumdisplay.php?fid=42)
+---- Thread: Latest beta firmware - changes (/showthread.php?tid=167)



Latest beta firmware - changes - admin - 06-23-2014

Release v1.0 firmware
  • Enabled serial ports for control of all functions using either RS232-1 or RS232-2. RS232-1 is 250,000 baud, RS232-2 is 9600 baud.
  • Added functions for changing baud rate of RS232-1 and RS232-2.
  • Added port checking for USB and serial port specific functions.



RE: Latest beta firmware - changes - admin - 11-20-2014

Release v1.1 firmware
  • Corrected problem with no flux areas no longer being written with v.9 and later firmware!
  • Fixed Erase Disk problem (wasn't erasing anything).



RE: Latest beta firmware - changes - Pmetzen - 01-16-2024

(06-23-2014, 07:26 PM)admin Wrote: Release v1.0  firmware
  • Enabled serial ports for control of all functions using either RS232-1 or RS232-2.  RS232-1 is 250,000 baud, RS232-2 is 9600 baud.
  • Added functions for changing baud rate of RS232-1 and RS232-2.
  • Added port checking for USB and serial port specific functions.

How do I activate the serial interfaces?


RE: Latest beta firmware - changes - admin - 01-17-2024

The serial ports are always enabled. You can just plug a RS232 interface into either serial port. There is information on the serial port usage in the API documentation.