03-02-2017, 10:47 PM
Pages: 1 2
05-08-2017, 03:20 PM
I have a question. I seem to have intermittent connectivity to my router. At the moment I can't get it to connect, although it did before.
My setup is a router I use as a wireless access point on the same desk as the Vic 20 so a good signal. This is connected by Ethernet to my main ADSL router. Both share the same SSID and password. When I perform a network scan both routers show up although the ADSL router has a weak signal -87dbm. The ADSL router is the one running the DHCP server and acting as gateway. I wonder which router should I connect to?
My setup is a router I use as a wireless access point on the same desk as the Vic 20 so a good signal. This is connected by Ethernet to my main ADSL router. Both share the same SSID and password. When I perform a network scan both routers show up although the ADSL router has a weak signal -87dbm. The ADSL router is the one running the DHCP server and acting as gateway. I wonder which router should I connect to?
05-08-2017, 03:36 PM
You should connect to the strongest signal possible. Just make sure you are in ASCII mode (not CBM graphics mode) in your terminal program when setting up the router's name/password. If you type ATI and see the text has the upper/lower case reversed from normal, then you are in the wrong mode! This is the #1 reason why people can't get their router to connect. You absolutely must be in ASCII mode when setting up the router.
Pages: 1 2