POWERPower-On Combos
Hold the keys while applying power. Release when the LED confirms.
SHIFT-LOCK+F1
Full factory reset — wipes all preferences and the keymap to defaults. F1 glows red until released.
SHIFT-LOCK+D
Keyboard diagnostic mode — lights each key LED as you press it so you can confirm every switch and the matrix scan are working. Requires a reboot to exit.
RUNTIMERuntime Combos
Press these any time after power-on.
SHIFT-LOCK+W (hold 3s)
Enable WiFi web UI — brings up the configuration interface (AP + web server). Hold for at least 3 seconds. The keyboard strobes yellow when the AP starts, then cyan each time a device successfully connects. Stays active until the next reboot.
SHIFT-LOCKToggle State
SHIFT-LOCKtap <1s
Toggle the SHIFT-LOCK latch on/off (virtual sticky-shift). Only if no combo was used during the press.
SHIFT-LOCKhold ≥2s
While recording a macro: stop & save the recording.
LEDSConfiguration
Hold SHIFT-LOCK un-latched, press the digit, then tap + / − to step. Min/max strobes the entire keyboard red.
S-LOCK+1++/−
LED Pattern (0–11)
S-LOCK+2++/−
Pattern Brightness (1–16)
S-LOCK+3++/−
Animation Speed (1–10)
S-LOCK+4++/−
Key Action (0–6)
S-LOCK+5++/−
Key Action Brightness (1–16)
MACROSPlay and Record
Hold SHIFT-LOCK un-latched, then the modifier, then a digit 0–9 (slot).
S-LOCK+L-SHIFT+0–9
Play USER macro from that slot.
S-LOCK+CTRL+0–9
Play SYSTEM macro from that slot. (Slot 1 = UNNEW.)
S-LOCK+CBM+0–9
Record USER macro into that slot. Stop by holding SHIFT-LOCK for 2s.
INFOLED Settings
Hold SHIFT-LOCK un-latched, press I, then a digit.
S-LOCK+I+1
Type the full settings status dump — clears the screen, prints
INFO 1 and all 16 setting lines.