AT*T1 and power-cycle
#1
Hi Jim

Is the AT*T1 setting supposed to survive a power cycle after I AT&W ?

It doesn't seem to, I find I have to re-issue the command every time.
The Workshop -  http://home.reidspace.com/ 

Reply
#2
Good question! I might have forgotten to add that to the AT&W command. I will look into it.
Reply
#3
Yep, you're right - the *T setting was not being saved. A new version of firmware is now available. Thanks for pointing this out!
Reply
#4
Cool, updated this morning, looks good.

Thanks
The Workshop -  http://home.reidspace.com/ 

Reply




Users browsing this thread: 1 Guest(s)