Firmware requests
#11
(01-05-2018, 08:04 AM)pawprintlogic1 Wrote: I see an update is available but when I type ATUPDATE or atupdate all I get is "error".. do I need to reset the modem??

Thanks!!

hiya

its at*update
The Workshop -  http://home.reidspace.com/ 

Reply
#12
With the v2.00 and later firmware, some command syntax was changed.  All WiModem specific commands now require a asterisks (*) between the AT and command.  So, ATUPDATE is now AT*UPDATE.
Reply
#13
I didn’t see if anyone else already asked, but how about displaying settings on the oled, like baudrate, handshake and so on. Not using the WiModem regularly, it happens, that I forget which settings I had applied.
Reply
#14
Ok, noted! I have already added an online timer in some beta code. I can look at adding the baud rate and handshake. It's always 8N1, so that info isn't needed.
Reply
#15
(05-04-2019, 05:04 PM)admin Wrote: Ok, noted!  I have already added an online timer in some beta code.  I can look at adding the baud rate and handshake.  It's always 8N1, so that info isn't needed.

+1 for adding baud rate to the display - I use the WiModem232 and move it among a few machines and this would make it easier to know what my settings should be.
Reply




Users browsing this thread: 1 Guest(s)