SCP Serial port support added!
#1
Both SCP serial ports have been activated with v1.0 of the firmware.  The default baud rate of the RS232-1 port is 250Kbps, and the default baud rate of RS232-2 port is 9600 baud.  You can of course change the baud rate to anything between 300 baud and 1.25 megabaud.  Changes to the baud are non-volatile, so a reset of the board will restore the default baud rates.  If anyone thinks that either of these should default to a lower baud rate, please let me know.
Reply




Users browsing this thread: 1 Guest(s)